|
|
|
PHONE Email: gs@gsgold.com
A Member of
|
TRUPD
.950
PALLADIUM WHITE
|
||||||||||||||||||||||||||
![[Most Recent Quotes from www.kitco.com]](http://kitconet.com/images/quotes_special.gif)
|
ALLOY NAME |
TruPd .950 "Tru-Palladium White Gold" |
|
ALLOY COLOR |
White no Rhodium Plating |
|
ALLOY DESCRIPTION |
General purpose |
|
PRODUCT FORMS AVAILABLE |
Casting grain, flat sheet, round wire, sizing wire, shape wire,
pattern wire, bezel strip & wire, jewelry findings. |
| RECOMMENDED USES |
.950 palladium is suitable for all
general fabrication techniques. It
can withstand high levels of deformation
between anneals. This alloy does not require rhodium plating. |
|
PROCESSING RECOMMENDATIONS |
|
| Working: |
For
best results, G&S recommend TruPd .950 palladium is reduced by a
minimum of 50% area/section thickness between anneals. |
| Annealing: |
If
using a furnace, anneal between 1650 - 1832°F (900 - 1000°C) for
15 – 30 minutes depending on size. If using as torch, heat to
an orange color. This alloy can be quenched after annealing. |
| Investment Casting: |
Melting range: 2462 - 2516°F (1350 - 1380°C). Casting temperature range: 2820 - 2910°F (1550 - 1600°C). Flask temperature range: 1250 - 1350°F (675 - 730°C). Investment type: Platinum (phosphate bonded). Cover gas: Argon. |
| TruPd must be cast
using similar techniques to platinum alloys due to the high
melting range of the alloy. Sprues and gates must be typical of
those used for platinum castings. TruPd must be melted under an argon protective atmosphere to prevent gas absorption. It is recommended that induction casting equipment with a sealed melt chamber be used. Ideally the melt chamber should be vacuumed after loading the charge, and then back-filled with argon. If an open crucible is used; care must be taken to ensure complete cover with argon. While it may be possible to successfully cast Tru-Pd using a torch, results cannot be guaranteed. Temperatures may differ from these recommendations depending on processing considerations. After casting, the flask may be quenched and de-vested once the button has returned to black heat. Final de-vesting may use
techniques standard to platinum alloy processing. |
|
| Soldering: |
Standard soldering techniques may be used with 950 palladium. |
| RECOMMENDED SOLDERS |
G&S palladium hard, medium and easy solder. |
| MATERIAL PROPERTIES |
Melting range: 2462 - 2516°F (1350 - 1380°C). Specific gravity: 11.84 Density: 6.24 troy ozs/in³ Hardness: Cast – 115 HV Annealed – 105HV Hard – 180HV |
PURCHASE ONLINE
TruPd .950 Palladium Casting Grain
TruPd .950 Palladium Flat Sheet
TruPd .950 Palladium Round Wire
TruPd .950 Palladium Bezel Strip
TruPd .950 Palladium Jewelry Findings
flat sheet, round wire, sizing wire, shape wire, pattern wire, bezel strip & wire, jewelry findings
All Jewelry Findings,
Casting Grain
and Mill Products prices in our shopping cart
are based on the London PM Fix and CHANGED DAILY.
Prices are subject to change
without notice.
